I N S T A L L A T I O N G U I D E Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com ® 5. Repeat this process for the tube on the other side, and install the remaining light strips. We recommend installing the: (2) 24” Strips ʂ On the lower tubular frame supports under the front bumper ʂ On the rear swing arm (2) 18” Strips ʂ On each angled section of the front bumper (2) 10” Strips ʂ In the grille and undertail area. (4) 6” Strips ʂ On the headlight support bar facing the engine bay area on each side ʂ Behind the front suspension area on both sides (6) 2” Strips ʂ Under the seat belt trim on both sides ʂ Around the side roll cage on both sides 6. Zip-ties should be used to secure any strips to the frame rails. 7. Once everything has been installed, we recommend running the power wires for the strips through the back of the vehicle, to the compartment under the passenger side headrest panel. Be sure to keep the wires away from any moving parts. Note: Add-on harnesses are used in order to connect different groups of wires together and run one wire to another location. Add-on harnesses can also be used in order to group specific light strips to be used with the dual zone feature. 8. Connect each strip to one of the 6 piece power harnesses and run the single side of the power harness down through the body panel to the underside. 9. Reinstall the headrest panel. 2 LEDGlow Lighting, LLC • LEDGlow.com Note: Recommended mounting locations below. The strips can be mounted in any area that isn’t hot or near moving parts.
RkJQdWJsaXNoZXIy MTIxODAy