16 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com set to GND. If your Golf Cart accessory switch circuit is controlled by power and the ground never changes, have the courtesy switch type set to 12V. See page 14 for more details. How to Hide the Wheel Well Tab: Press the settings tab ( ) and toggle the wheel well tab to “off.” How to Hide the Interior/Canopy Tab: Press the settings tab ( ) and toggle the interior tab to “off.” How to Save a Preset: Determine the mode and color choices desired to save as a preset. For Android users, press and hold down for 2 seconds on the selected preset number, which will prompt a confirmation message on the screen indicating that the preset has been saved. For iOS users, press and hold down on the desired preset number to save and press “OK” after the popup notification appears. How to Reset the App: Go to the settings tab ( ) and tap on “Reset Settings.” This will reset all settings back to default. SECTION 14: FUNCTIONALITY The names, order, and descriptions of the modes are: Solid: Sets the kit to a solid color chosen from the color wheel. If more than one color is selected, the color will switch instantly to the next. Pulse: Gradually fades the light then flashes back on in a pulse effect. Sweeping: Lights up the entire front of the kit and gradually runs down the sides until reaching the rear in a sweeping motion. Kitt Scanner: Creates a scanning motion beginning at the center of the front of the kit that extends to the sides and ends at the center of the rear. Karr Scanner: Similar to Kitt Scanner, but creates a scanning motion that begins simultaneously at the center of the front and rear tubes. The light then moves from both ends of the vehicle to the opposite ends of the vehicle, passing through each other halfway down the sides, ending at the center of the opposite ends of the vehicle. Chase: Gradually lights up the entire front section of the kit, then trickles down the sides until reaching the rear tube in a chase pattern. Color Chase: Creates a chasing effect that starts in the front of the kit, reaches the rear, and then meets back again in the center of the sides. This mode works best with two or more colors selected. Chase vs Chase: Creates a chasing effect from both the front and rear, crossing each other in the center of the sides. This mode works best with two or more colors selected. Progression: Lights up the front entirely along with select parts of the sides as they scan front to back until reaching the rear. Running Color: Creates a scanning color effect on top of a solid color.
RkJQdWJsaXNoZXIy MTIxODAy