15 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com SECTION 13: HOW TO USE THE APP How to Add a Single Color: Tap on the color bar until it expands into the color wheel. Select the desired color in the expanded color wheel and tap it to create a programmed color. Note: Be sure only one color is selected for solid illumination. How to Add a Second or Third Color: On the right side of the color wheel there are three white outlined circles. Tap each of the three circles and select a color from the color wheel. How to Remove a Second or Third Color: Expand the color wheel by tapping on the color bar if the color wheel is not already expanded. For Android users, press and hold the desired color to be removed. For iOS users, select the color you want to eliminate by pressing and holding for 2 seconds. Press the “X” to complete. How to Link/Unlink the Wheel Well or Interior Components: Different components of the kit can be operated together or independently of each other. Linking components together will allow the same colors and patterns to be used across them. Unlinking components will allow each of them to be controlled independently. Locate the link icon on the main underbody tab, or by tapping on either the “WHEEL” or “INTERIOR/CANOPY” tabs. Tap the link icon ( ) once to unlink the selected section. Tap the link icon again to link them together. How to Turn on the Million Color Mode: Million Color Mode cycles through all available colors. To turn it on or off, tap on the color bar to expand the color wheel. Use the toggle option to turn the Million Color Mode either on or off. Program the Million Color Mode on a selected component or assign this mode to all available components. How to Turn on the Fade Mode: Expand the color wheel by tapping on the color bar. After the color wheel is expanded, utilize the available toggle option to turn the fade mode on or off for integrating a fading transition to selected kit areas. How to Change the Speed on a Mode: Program more than one color on the app and slide the speed bar to adjust the color transition and/or mode. How to Turn on the Strobe Mode: Locate the strobe toggle located above the mode bar near the bottom of the app screen. Slide the white circle on the strobe bar to on or off to integrate a white strobing effect into any mode. How to Change the Brightness: Check the app screen to verify that the color wheel is expanded. Tapping the color bar will expand the color wheel if needed. Locate the brightness bar under the color wheel. Use the slider to decrease or increase color brightness. How to Change a Mode: Scroll to the bottom of the page and tap on “mode.” Tap on the list to select a mode. How to Turn on the Courtesy Lights: Press the settings tab ( ). Find the Courtesy Light Feature section and set it to “on” by sliding the toggle. How to Change 12V or GND for Courtesy Lights: Press the settings tab ( ). Once in settings, you will see the option to toggle between 12V and GND. If your Golf Cart has a ground side controlled system with constant power to the accessory switch, have the courtesy switch type
RkJQdWJsaXNoZXIy MTIxODAy