17 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com Flash: Flashes all lights simultaneously. Wig Wag: Lights up the front and rear simultaneously. After the front and rear illuminate, both of the sides light up simultaneously. Solid Zone: Flashes solid sections of the front and back while the sides flash simultaneously. Section Pulse: Creates a pulse effect that cycles through the kit. Light Show: Creates a scanning effect that cycles through the kit and then stops and flashes. Once it is finished flashing, it begins scanning again. Equalizer: Starting at the center of the front tube, solid light radiates outward, extending to the side tubes, then to the rear tube, illuminating the rear tube from the outside ends to the center, eventually lighting all of the tubes simultaneously. The pattern then moves back to the front of the vehicle in reverse, shutting off the lights as it radiates back to the center of the front tube. SECTION 15: TIPS & TROUBLESHOOTING The LEDGlow Golf Cart Control App will not disconnect while multitasking between other apps or phone features. Force-closing the app will not automatically shut down the kit. Shut down the app by double-tapping your mobile device’s “back” button when utilizing the app. Pairing will automatically occur after the initial app setup, as long as Bluetooth is turned on in the iOS or Android app settings and the controller is fully powered. If the Android or iOS device cannot connect to the controller, try one of the following steps and then reopen the LEDGlow Golf Cart Control App: Restart or select the power cycle option on any Android or iOS device. Restart your Bluetooth-enabled control box by disconnecting its power for 20 seconds, reconnect power, and test the kit for proper functionality.
RkJQdWJsaXNoZXIy MTIxODAy