LEDGlow Smartphone Underbody Kit with Bluetooth Control

Tech Support 856.768.5700 Ext.2 • TechSupport@LEDGlow.com 5 INSTALLATION GUIDE Section 5: Wheel Well Add-On Tube Installation (Optional) 1. (Optional) Remove the vehicle’s wheels for better access to the wheel well mounting locations. 2. Before mounting the wheel well tubes, ensure that all four tubes will be positioned 8-10” away from excessive heat or any moving parts. When mounting the tubes, ensure the power wires are facing the front of the vehicle. 3. Mount the 24” driver’s side tube either behind the wheel strut facing toward the wheel or inside of the inner fender well by using the included self-tapping screws. The 24” wheel well tubes are flexible and can be contoured easily for precise positioning. Repeat this step for the remaining (3) 24” wheel well tubes, keeping their placement consistent with the driver’s side tube installation. 4. Reinstall your vehicle’s wheels if they were removed in accordance to factory specifications. 5. Test the clearance of the wheel well tubes by moving the steering wheel back and forth to confirm that the tubes do not interfere with the wheels in any way. Section 4: Truck Add-On Tube Installation (Optional) 1. Before mounting the truck add-on tubes, ensure that both 24” tubes will be positioned 8-10” away from excessive heat or any moving parts. When mounting the tubes, ensure the power wires are facing the vehicle’s rear. The tubes should be mounted behind the driver and passenger side underbody tubes to cover major gaps between the side and rear tubes. 2. Mark drill locations for the mounting brackets on a level surface. Use a 7/64” drill bit to drill pilot holes for the mounting brackets and install the mounting brackets with the included screws through the pilot holes. We recommend using 2-3 brackets per tube. 3. Peel any clear film off of the underbody truck tubes. 4. Snap the (2) 24” underbody tubes into the mounting brackets and secure them in place using the included zip-ties. Section 6: Grille Add-On Tube Installation (Optional) 1. Lower the vehicle (if previously raised). 2. Arrange the grille tube in the desired location behind the vehicle’s grille, positioning it 8-10” away from excessive heat or moving parts. The orientation of the grille tube’s power wire should match that of the installed front underbody tube. For example, if the front underbody tube’s power wire is on the passenger’s side of the vehicle, the grille tube’s power wire should also be on the passenger’s side of the vehicle. 3. Peel any clear film off of the grille tube. 4. Use the included mounting brackets and screws to secure the tube behind the vehicle’s grille, securing the tube in place using the included zip-ties. Take care not to screw the brackets into the radiator, AC condenser, any sensors, or other vital engine components in this part of the vehicle.

RkJQdWJsaXNoZXIy MTIxODAy