4 Tech Support 856.768.5700 Ext.2 • TechSupport@LEDGlow.com INSTALLATION GUIDE 1. Disconnect the negative side of the vehicle’s battery. 2. Raise the vehicle (if possible). 3. Using the 36” tube with the 18’ power wire, mock up its mounting location at the rear of the vehicle. The orientation of the wire will not affect the functionality of the kit – the wire can be positioned on either side of the vehicle. However, the tube must be positioned 8-10” away from excessive heat or moving parts. 4. Mock up the remaining 36” tube to the front of the vehicle 8-10” away from excessive heat or moving parts. Much like the rear underbody tube, the orientation of the wire will not affect the functionality of the kit – the wire can be positioned on either side of the vehicle. If a Grille Add-on Kit was also purchased, refer to Section 6 to mount the additional 24” tube that came with the Grille Add-on kit. 5. Mock up the (2) 46” tubes on both of the vehicle’s sides. Face the power wires of the 46” side underbody tubes toward the vehicle’s rear, making sure to place the tubes 8-10” away from excessive heat or moving parts. If a Truck Add-on Kit was also purchased, refer to Section 4 on page 5 to mount the additional 24” tubes that came with the Truck Add-on kit. 6. Mark drill locations for the mounting brackets on a level surface facing inward or outward, depending on tube placement preference. Use a 7/64” drill bit to drill pilot holes in the mounting bracket locations and attach the brackets to the vehicle using the included screws. We recommend using 2-3 brackets per tube for 24” and 36” tubes, and 3-4 brackets for 46” tubes. 7. Peel any clear film off of the underbody tubes. 8. Snap the 36” underbody tube with the 18’ power wire into the rear mounting brackets. Snap the other 36” tube into the front mounting brackets. Snap the (2) 46” underbody tubes into the side mounting brackets and secure all tubes into the brackets with the included zip-ties. Refer to sections 4-7 for additional details on optional truck, wheel well, grille, and interior add-on tube installation instructions. If no add-on kits were purchased, skip to Section 8. Section 3: Underbody Tube Installation
RkJQdWJsaXNoZXIy MTIxODAy