2 LEDGlow Lighting, LLC • LEDGlow.com Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com INSTALLATION GUIDE 10. Mount a 6” strip under the left side fork cover. 11. Mount a 10” strip under the left side of the tank. 12. Mount a 2” strip under the horn facing the engine. 13. Mount an 18” strip on the lower left side of the frame rail to illuminate under the bike. 14. Mount a 4” strip on the frame brace above the starter. 15. Mount an 8” strip on the bottom of the swing arm on the left side. 16. Take (1) 12” strip and (1) 6” strip and mount them to the saddle bag supports facing the ground and rear wheel on the left side of the bike. 17. Mount a 6” strip to the fork cover on the right side, followed by a 10” strip under the tank. 18. Mount a 2” strip behind the air cleaner facing the engine. 19. Mount an 18” strip under the right side frame rail to illuminate under the bike. 20. Mount an 8” strip on the bottom of the swing arm on the right side. 21. Take (1) 12” strip and (1) 6” strip and mount them to the saddle bag supports facing the ground and rear wheel on the right side of the bike. • Once all of the lighting strips are mounted, we will begin wiring the control box using the Add-On Power Harness for Harley Davidson Touring Motorcycles. 22. Locate the factory four-way Deutsch socket housing under the seat near the ECU and remove the rubber plug. Then, plug the Add-On Harness into the factory four-way Deutsch socket housing and connect the opposite end with the factory rubber plug if it is not being used. 23. If your bike is equipped with an auxiliary switch, determine if you would like to have the kit controlled by the ignition or the auxiliary switch. • If you wish to control the kit with the ignition switch, connect the Red Wire of the control box to the Red Wire on the Add-On Harness. • If you wish to control the kit with the auxiliary switch, connect the Red Wire of the control box to the Yellow Wire on the Add-On Harness. 24. Connect the Blue Wire from the control box to the Blue Wire on the Add-On Harness for the Automatic Brake Lights feature. • Doing this will allow the entire lighting kit to turn red and act as a brake light any time the brake lever or brake pedal is engaged. When released, the kit will return to its last setting. 25. Connect the Black Wire of the control box to the Black Wire of the Add-On Harness for ground. • Now that we have the control box wired for power, we will begin wiring the lighting strips. Note: Add-On Harnesses are used to connect different groups of wires and run one wire to another location. Add-On Harnesses can also be used to group specific light strips to be used with the Dual Zone feature that is available when using the Bluetooth Advanced Million Color Motorcycle Control Box. 26. Plug the 2pc Power Harness into your control box (If installing the kit using the Smartphone Control Box Upgrade, Skip to Step 28) 27. Run the wires to the planned mounting location of the control box and secure them to the bike frame by using the included Zip Ties. WARNING: DO NOT SHORTEN OR CUT ANY WIRES; YOU WILL VOID THE WARRANTY. Once this step is complete, and the lighting strips and wires are secure, you can now test the functionality of your kit by pressing the on/off button on the wireless remote.
RkJQdWJsaXNoZXIy MTIxODAy