Tech Suppor t 856.768.5700 Ext.2 • TechSuppor t@LEDGlow.com 5 I NSTAL LAT I ON GU I DE Section 5: How to use the App • How to Add a Single Color: Tap on the color bar until it expands into the color wheel. Select the desired color in the expanded color wheel and tap it to create a programmed color. • How to Add a Second or Third Color: On the right side of the color wheel, there are three white outlined circles. Tap each of the three circles and select a color from the color wheel. • How to Remove a Second or Third Color: Expand the color wheel by tapping on the color bar if the color wheel is not already expanded. For Android users, press and hold the desired color to be removed. For iOS users, select the color you want to eliminate by pressing and holding for 2 seconds. Press the “X” to complete. • How to Turn on the Million Color Mode: Million Color Mode cycles through all available colors. To turn it on or off, tap on the color bar to expand the color wheel. Use the toggle option to turn the Million Color Mode either on or off. • How to Turn on the Fade Mode: Expand the color wheel by tapping on the color bar. After the color wheel is expanded, utilize the available toggle option to turn the fade mode on or off for integrating a fading transition. • How to Change the Speed on a Mode: Program more than one color on the app and slide the speed bar to adjust the color transition and/or mode. • How to Turn on the Strobe Mode: Locate the strobe toggle located above the mode bar near the bottom of the app screen. Slide the white circle on the strobe bar to on or off to integrate a white strobing effect into any mode. • How to Change the Brightness: Check the app screen to verify that the color wheel is expanded. Tapping the color bar will expand the color wheel if needed. Locate the brightness bar under the color wheel. Use the toggle to decrease or increase color brightness. • How to Change a Mode: Scroll to the bottom of the page and tap on “mode.” Tap on the list to select a mode. • How to Turn on the Courtesy Lights: Press the settings tab (the gear icon on the top right corner of the app.) Find the Courtesy Light Feature section and set it to “on” by sliding the toggle. • How To Set a Courtesy Light Color: When the Courtesy Light feature is active, the 7 solid color options available to choose from for the Courtesy Light will be displayed. • How to Change 12V or GND for Courtesy Lights: Press the settings tab (the gear icon on the top right corner of the app.) Once in settings, you will see the option to toggle between 12V and GND. If your vehicle has a ground side controlled system with constant power to the dome light, have the courtesy switch type set to GND. If your vehicle’s dome light circuit is controlled by power and the ground never changes, have the courtesy switch type set to 12V. • How to Save a Preset: Determine the mode and color choices desired to save as a preset. For Android users, press and hold down for 2 seconds on the selected preset number, which will prompt a confirmation message on the screen indicating that the preset has been saved. For iOS users, press and hold down on the desired preset number to save and press “OK” after the popup notification appears. • How to Reset the App: Go to the settings tab (the gear icon on the top right corner of the app) and tap on “Reset Settings.” This will reset all settings back to default. Section 6: Names and Descriptions of the Modes: • Solid: Sets the kit to a solid color chosen from the color wheel. If more than one color is selected, the color will switch instantly to the next. • Pulse: Gradually fades the light then flashes back on in a pulse effect. • Sweeping: Lights up the entire front of the kit and gradually runs down the sides until reaching the rear in a sweeping motion. • Color Chase: Similar to Pulse, but each pulse is multiple chasing colors. This mode works best with two or more colors selected. • Flash: Flashes all lights simultaneously.
RkJQdWJsaXNoZXIy MTIxODAy