2 Tech Suppor t 856.768.5700 Ext.2 • TechSuppor t@LEDGlow.com I NSTAL LAT I ON GU I DE WARNING: Please check your state and local laws before installing this LED lighting kit. Every state has different policies and procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using this lighting kit. This kit is for off-road use only. WARNING: It is recommended that this Million Color Interior Lighting Kit is installed by a licensed professional. The improper installation of this kit will void all warranties. This interior lighting kit must be installed in a dry location! Having this part exposed to water or the elements will cause the kit to fail. Any water damage or corrosion to this part will void all warranties. Expandability Options: This Million Color Pro SMD Interior Lighting Kit can be expanded to power a total of (12) 12” flexible tubes. PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS INTERIOR LIGHTING KIT. Continued 1. WARNING: Do not turn on or connect power to the control box until all of the cables and tubes are properly connected. 2. Each interior tube can be mounted virtually anywhere in the vehicle. Our recommended locations are under the dashboard facing the footwell area, under the driver and passenger seats facing the footwell area, under the back of the driver and passenger seats facing the back seats or even in the trunk. 3. OPTIONAL: Remove any trim pieces from the interior of the vehicle that may hinder the installation of the interior tubes. 4. Starting with the front tubes, mount them with plenty of clearance from any moving parts such as the steering shaft and pedals. You can use the included Adhesive Tape to secure the tubes in place, or you can use zip ties. Repeat this step with the remaining tubes. 5. Now that the tubes are installed, run the cables to each tube. There are two output plugs located on the side of the control box which are used to power the LED interior tubes. Each output on the controller can hold up to (6) 12” Flexible Tubes allowing for a total of (12) 12” Tubes. Start by plugging the lead tube cable into one of the output ports on the control box and then into the first tube. Each tube then daisy chains to the next tube in the sequence by using the linking cables for a quick and easy connection. You can use either one or both of the outputs, but the two daisy chains will not link together in a loop. Make sure the cables are not close to the seat tracks or anything else that may potentially cut or pinch the cables. Secure any excess wiring using zip ties. 6. Find a safe, secure and dry location to mount the control box. We recommend mounting the control box in your center console, under the seat, under the dashboard or in your glove box. Section 2: Million Color Pro SMD Interior Lighting Kit Installation
RkJQdWJsaXNoZXIy MTIxODAy