6 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com Step 1: Identify Battery Type & Confirm System Voltage Determine whether your cart uses: • Lead-acid batteries (flooded, AGM, gel) • Lithium battery system • Smart lithium battery system (with built-in BMS) If you are unsure of the system voltage: 1. Temporarily reconnect the main negative battery terminal (if disconnected). 2. Use a multimeter set to DC Volts. 3. Measure total system voltage before installing the reducer. Common Configurations (Not Limited To): 36 Volt Systems • (6) 6V batteries (Fig 6.) 48 Volt Systems • (6) 8V batteries (Fig 5.) • (4) 12V batteries (Fig 3.) • (1) 48V lithium battery (Fig 2.) 72 Volt Systems • (6) 12V batteries (Fig 4.) • (1) 72V lithium battery (Fig 2.) : Confirm total system voltage before connecting the Voltage Reducer. Incorrect installation may cause overheating, reducer failure, and potential damage to the golf cart or lighting kit. Step 2: Power Down the Golf Cart 1. Switch the cart to TOW mode (if equipped). 2. Turn the key switch to OFF. 3. Disconnect the main negative battery terminal. Step 3: Locate Correct Connection Points Electric golf carts often use batteries wired in series to achieve total system voltage. It is critical that the Voltage Reducer connects to the main system positive and main system negative terminals where full pack voltage is present. If the voltage is coming from a stock reducer, ensure the maximum amperage does not exceed 5AMP.
RkJQdWJsaXNoZXIy MTIxODAy