2 Tech Support 856.768.5700 Ext.2 • TechSupport@LEDGlow.com INSTALLATION GUIDE 1. Arrange the underbody tubes as they would be placed on the vehicle. For proper placement of tubes, refer to section 3. 2. If purchased, arrange the truck, wheel well, grille, and interior add-on tubes as they would be placed on the vehicle. For proper placement of add-on tubes, refer to sections 4-7. 3. Plug all underbody tube wires into the provided distributor cable. 4. If purchased, plug all wheel well tube wires into the wheel well tube distributor cable. Plug the front wheel well tubes into the ports labeled “F” and the rear wheel well tubes into the ports labeled “R.” 5. If purchased, plug all interior tube wires into the interior tube distributor cable. 6. If purchased, plug the Display Module into the port on the control box labeled “DISPLAY”. 7. Plug the underbody tube distributor cable into the port on the control box labeled “UNDERBODY.” 8. If purchased, plug the cable of the wheel well tube distributor cable into the port on the control box labeled “WHEEL WELL.” 9. If purchased, plug the interior tube distributor cable into the port on the control box labeled “INTERIOR.” 10. Temporarily power your kit with any 12 volt source to ensure it is functioning properly before moving forward with the installation. Simply connect the red wire from the control box to a positive 12 volt source and connect the black wire to any good ground source. Confirm all light tubes illuminate and pair the control box to your device following the steps in section 2. 11. Once the kit has been confirmed to be working properly, disconnect it from its power source and make all components available for installation. Section 1: How to Test Your Kit
RkJQdWJsaXNoZXIy MTIxODAy