6 LEDGlow Lighting, LLC • LEDGlow.com Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com ® INSTALLATION GUIDE Device Pairing Tips & Troubleshooting • Disconnect from the control box when you are not using it to preserve your bike's battery life. You cannot turn off bluetooth within the app. To disconnect from the control box you must exit the app and completely close it out so that the app is no longer running on the phone. Exiting the LEDGlow Motorcycle Control App will not disconnect your iOS device from the controller as the app was designed for multitasking with other apps, such as answering a phone call, or surfing the web and then switching back to the LEDGlow Motorcycle Control App. The same can be done in the Android version by either turning off Bluetooth in the phone's settings app, or by shutting down the app by double tapping on your device’s “Back” button while inside the app. • This control box is designed with a power save mode that automatically turns on after 8 hours of inactivity. This allows the control box to draw minimum power, ensuring it does not drain your Spyder’s battery. It may take an additional minute when attempting to reconnect back to the controller while it is currently in power save mode, if you are using iOS. To prevent any battery drain when not in use, you can install the control box to a 12 volt switched source to completely remove power at your choosing. • If you have Bluetooth switched “On” in your Settings app and the controller is powered, your iOS device will attempt to connect to the controller whenever it is in range. You do not need to pair and manually connect to the controller after the initial setup if you are using the same device. Your Android device will connect once your device pairs to your control box and you open the app. • In the event that your Android/iOS device cannot connect to the controller, try one of the following: ʂ Completely close out of the app and ensure that it is not running in the background on your phone. Then Open the app ʂ Restart your Bluetooth enabled control box by disconnecting power to it for 20 seconds • The control box operates independently from the app. If your Android/iOS device is not available for use, the control box provides full lighting functionality with color, mode, and speed buttons. This kit is designed to fully operate in conjunction with the wireless remote and without the LEDGlow Motorcycle Control App. You cannot save any presets from the remote; therefore, once you reopen the app, the current lighting configuration shown on your device’s screen will be immediately synchronized back to the controller. • You can have only one phone paired to your control box at a time. To pair a different device, disconnect the first device within the device's Bluetooth settings and pair the second device as described on pages 4 or 5, depending on the device's operating system.
RkJQdWJsaXNoZXIy MTIxODAy