4 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com 3. The surface area must be free of all oils, moisture, dirt, and wax so that the supplied adhesive tape can bond and adhere to the installation surface correctly. Be sure to clean all of the mounting areas with alcohol prep pads and apply adhesion promoter to the cleaned areas. 4. Attach the strips by removing the backing of the tape and pressing firmly onto the desired mounting locations, and secure them with zip ties when possible. Note: Be sure to use Zip Ties to secure the lighting strips where possible. This will provide extra security to ensure the lighting strips stay in place while riding in rough conditions. 5. Connect the Red Wire from the control box to the positive side of the battery using a ring terminal. 6. Connect the Blue Wire from the control box to the brake signal wire for the Automatic Brake Lights feature. • Doing this will allow the entire lighting kit to turn red and act as a brake light any time the brake lever or brake pedal is engaged. When released, the kit will return to its last setting. • The brake light signal wire may vary from year to year and changes depending on the location you are connecting to. Use a test light to verify the correct wire. The test light should illuminate with both the hand lever and foot pedal. 7. Connect the Black Wire of the control box to the negative side of the battery or to a clean and secure grounding location. 8. Now that we have the control box wired for power, we will begin wiring the lighting strips.
RkJQdWJsaXNoZXIy MTIxODAy