7 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com replace the fuse and test the kit again. If the inline fuse is intact, clean both the positive and negative terminals of the battery. Corrosion of the battery terminals can cause a poor connection or simulate being disconnected. For accessories, add-on kits, replacement parts, and/or Technical Support, please visit www.LEDGlow. com for more information. DUAL ZONE WIRING FOR SMARTPHONE CONTROL BOX UPGRADE **If using the Smartphone Control Box we recommend wiring the kit in two different sections or “Zones,” separating the lights from the engine area and the lights on the rest of the bike. This will allow you to display two different colors at the same time. Below are the steps to have the engine zone separated from the rest of the bike** 23. Plug the 6pc power harness into one of the open plugs on the Smartphone Control Box. 24. Route the 6pc power harness to the area under the seat Connect the following lights to the 6pc harness and 2pc add-on harness and use Zip Ties to secure the wires, being sure to stay clear of any moving parts or direct heat sources: • (3) strips under the tank • (1) 4” strip behind the air cleaner • (2) 6” strips on the frame down tubes • (1) 2” strip in front of the oil tank and battery location 25. Plug the second 6pc power harness into the remaining plug on the Smartphone Control Box. Connect the following lights to the 6pc harness and use Zip Ties to secure the wires, being sure to stay clear of any moving parts or direct heat sources: • (2) 10” strips under the rear fender struts • (3) 6” strips on the rear swing arm • (1) 2” strip under the Air Cleaner • (1) 4” strip under the triple tree (Utilize a 2pc add-on harness and extension if needed. The open port can be used to add more lights at a later time.) 26. Plug the 6pc add-on harness into a port on either the 6pc power harness or 2pc add-on harness and connect the (7) 4” strips under the frame. Note: There will be 1 unused plug on the harness that can be used for expanding the kit. Be sure to wrap the unused connector in electrical tape or heat shrink to ensure it stays clean and dry. 27. Reinstall the battery panel and seat.
RkJQdWJsaXNoZXIy MTIxODAy