6 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com Note: Add-On Harnesses are used to connect different groups of wires and run one wire to another location. Add-On Harnesses can also be used to group specific light strips to be used with the Dual Zone feature that is available ONLY when using the Bluetooth Advanced Million Color Motorcycle Control Box. With this in mind the lights can be grouped to illuminate the engine separately from the rest of the bike or you can group the left and right sides. 21. Plug the 2pc Power Harness into your control box (If installing the kit using the Smartphone Control Box Upgrade, Skip to Step 23) 22. Run the wires to the planned mounting location of the control box and secure them to the bike frame by using the included Zip Ties. WARNING: DO NOT SHORTEN OR CUT ANY WIRES SINCE IT WILL VOID THE WARRANTY. Once this step is complete, and the lighting strips and wires are secure, you can now test the functionality of your kit by pressing the On/Off button on the wireless remote. Wireless Remote Functions: This kit provides multiple lighting patterns and several brightness levels, which are easily operated using the included wireless remote. The remote consists of four buttons: “A, B, C, D.” • Button A: Cycles through 15 Solid Colors as well as a Color Cycle and a Color Fade pattern. • Hold for 5 seconds to select the brightness level when on a solid color. • Button B: Activates Strobing pattern when a single color is selected. • Hold to increase pattern speed when on Color Cycle/Color Fade pattern. • Button C: Activates Fading pattern when a single color is selected. • Hold to decrease pattern speed when on Color Cycle/Color Fade pattern. • Button D: Power On/Off. Reprogramming the Wireless Remote: This procedure is going to be used for programming an existing or brand-new wireless remote to the control box. • If the control box is currently connected to power and ground, please disconnect the ground wire from the ground source. • Reconnect the ground wire back to the ground source, and once this is connected, the lights on the strips will turn green. • Within 5 seconds from when the kit turns green, you can press the A and then the B button on the wireless remote. If the programming is successful, the light strips will flicker green twice, and the kit will remain powered on. If the remote is not controlling the system, please repeat the steps above. Troubleshooting: If the kit or lights do not appear to operate, first check the installed inline mini fuse. If the fuse is blown, check the wires on the entire kit to ensure they are not cut, pinched, or scorched. If there is no damage to any of the wires and no water damage visible on the control box,
RkJQdWJsaXNoZXIy MTIxODAy