5 INSTALLATION GUIDE Tech Support 856-768-5700 Ext. 2 • TechSupport@LEDGlow.com LEDGlow Lighting, LLC • LEDGlow.com 4. The surface area must be free of all oils, moisture, dirt, and wax so that the supplied adhesive tape can bond and adhere to the installation surface correctly. Be sure to clean all of the mounting areas with alcohol prep pads and apply adhesion promoter to the cleaned areas. 5. Attach the strips by pressing firmly onto the desired mounting locations, and secure them with zip ties when possible. Note: Be sure to use Zip Ties to secure the lighting strips where possible. This will provide extra security to ensure the lighting strips stay in place while riding in rough conditions. 6. Starting with (1) 4” strip, attach it to the triple tree under the headlight. 7. Mount (2) 6” strips on the frame down tubes facing the engine. 8. Mount (1) 4” strip and (1) 2” strip under the left side of the fuel tank. 9. Mount (4) 4” strips on the lower left side of the frame rail: 3 going front-to-back and 1 going side-to-side to illuminate under the bike. 10. Mount (1) 2” strip in front of the oil tank and battery location facing the engine. 11. Mount (2) 6” strips on the bottom of the swing arm on: 1 on the left side and 1 on the center. 12. Mount (1) 10” strip to the Rear Fender Strut of the rear wheel on the left side of the bike, ensuring it faces the ground. 13. Mount (1) 4” strip behind the air cleaner facing the engine. 14. Mount (1) 10” strip under the right side of the fuel tank. 15. Mount (3) 4” strips on the lower right side of the frame rail going front-to-back to illuminate underneath the bike. 16. Mount (1) 6” strip on the bottom of the swing arm on and 1 on the right side. 17. Mount (1) 10” strip to the Rear Fender Strut of the rear wheel on the right side of the bike, ensuring it faces the ground. 18. Connect the Red Wire from the control box to the positive side of the battery using a ring terminal. 19. Connect the Blue Wire from the control box to the brake signal wire for the Automatic Brake Lights feature. • Doing this will allow the entire lighting kit to turn red and act as a brake light any time the brake lever or brake pedal is engaged. When released, the kit will return to its last setting. • The brake light signal wire may vary from year to year and changes depending on the location you are connecting to. In most cases it is a blue wire with an orange strip that changes to a purple wire. Use a test light to verify the correct wire. The test light should illuminate with both the hand lever and foot pedal. 20. Connect the Black Wire of the control box to the negative side of the battery or to a clean and secure grounding location. Now that we have the control box wired for power, we will begin wiring the lighting strips.
RkJQdWJsaXNoZXIy MTIxODAy