6 Tech Support 856.768.5700 Ext.2 • TechSupport@LEDGlow.com INSTALLATION GUIDE 1. Determine the desired location of the interior tubes, ensuring that the power wires are not near the seat rails so that they do not get pinched. Recommended interior tube placements include under the dashboard, under the front seats, and under the rear seats. Note: The orientation of the interior tube power wires will not impact installation, allowing for versatile mounting options. 2. Clean any dirt, oil, or dust from the surface of each mounting location using an alcohol prep pad (not included). 3. Using 3M™ tape and screws, mount the interior tube brackets to your preferred mounting locations and snap the interior tubes into the brackets. Mount the tubes securely. If mounting tubes under the dashboard, keep the tubes and wires away from the pedals. Use the included zip-ties to mount the tubes if they cannot be mounted to a flat location using brackets. 4. Wires can be hidden in a variety of ways according to preference. Options include removing trim panels and securing the wires with zip-ties. Please remove and replace trim per factory specification. Wires may also be hidden under seats or under the vehicle’s carpet. We suggest routing wires alongside factory wiring harnesses. Section 7: Interior Add-On Tube Installation (Optional) Section 8: Routing the Wires 1. Inspect your vehicle’s engine bay for available openings to mount the water-resistant control box, underbody tube distributor cable, and wheel well tube distributor cable (if purchased). Ensure that the location of the control box allows access and reach for all distributor cables to plug in properly. Plan to place the control box and distributor cable(s) in the driest possible part of the engine bay away from excessive heat or any moving parts. 2. Raise the vehicle (if possible). 3. Beginning at the back of the vehicle, route the wires from all installed light tubes toward the location of the control box in the engine bay, keeping the wires clear of excessive heat and any moving parts. Bind any excess power wire lengths from tubes tightly and secure with zip-ties, but avoid over-tightening them so that they do not splice open, which will void all warranties. 4. Plug the wires for all underbody tubes into the included distributor cable. 5. If wheel well lights are installed, plug the wires from the wheel well tubes into the wheel well tube distributor cable. Plug the front wheel well tubes into the ports labeled “F” and plug the rear wheel well tubes into the ports labeled “R.” 6. Lower the vehicle (if it was raised). 7. Mount the control box inside the engine bay using 3M™ tape and screws, ensuring that the LEDGlow logo is facing upright. Mount the underbody and optional wheel well tube distributor cables in their determined locations with 3M™ tape and screws. Use caution when using screws to confirm no vital engine components are damaged. 8. If you purchased the optional Display Module, route its wire from inside the vehicle through the firewall with a grommet in place. Plug the Display Module wire into the port on the control box labeled “DISPLAY.” 9. If interior lights have been installed, find a safe location to mount the interior tube distributor cable inside of the vehicle away from the pedals, steering shaft, direct heat sources, and any moving parts. Recommended locations include the center console, underneath the seat, under the dashboard, or inside the glove box. Mount the interior tube distributor cable in the vehicle’s interior using 3M™ tape and screws. Run the cable from the interior tube distributor cable through the firewall with a grommet in place to the control box and plug it into the port labeled “INTERIOR.” 10. Plug the cable of the underbody distributor cable into the port on the control box labeled “UNDERBODY.” 11. Plug the cable from the optional wheel well tube distributor cable into the port on the control box labeled “WHEEL WELL.”
RkJQdWJsaXNoZXIy MTIxODAy