12 Tech Support 856.768.5700 Ext.2 • TechSupport@LEDGlow.com INSTALLATION GUIDE Section 14: Functionality • Solid: Sets the kit to a solid color chosen from the color wheel. If more than one color is selected, the color will switch instantly to the next. • Pulse: Gradually fades the light then flashes back on in a pulse effect. • Sweeping: Lights up the entire front of the kit and gradually runs down the sides until reaching the rear in a sweeping motion. • Kitt Scanner: Creates a scanning motion beginning at the center of the front of the kit that extends to the sides and ends at the center of the rear. • Karr Scanner: Similar to Kitt Scanner, but creates a scanning motion that begins simultaneously at the center of the front and rear tubes. The light then moves from both ends of the vehicle to the opposite ends of the vehicle, passing through each other halfway down the sides, ending at the center of the opposite ends of the vehicle. • Chase: Gradually lights up the entire front section of the kit, then trickles down the sides until reaching the rear tube in a chase pattern. • Color Chase: Creates a chasing effect that starts in the front of the kit, reaches the rear, and then meets back again in the center of the sides. This mode works best with two or more colors selected. • Chase vs Chase: Creates a chasing effect from both the front and rear, crossing each other in the center of the sides. This mode works best with two or more colors selected. • Progression: Lights up the front entirely along with select parts of the sides as they scan front to back until reaching the rear. • Running Color: Creates a scanning color effect on top of a solid color. • Flash: Flashes all lights simultaneously. • Wig Wag: Lights up the front and rear simultaneously. After the front and rear illuminate, both of the sides light up simultaneously. • Solid Zone: Flashes solid sections of the front and back while the sides flash simultaneously. • Section Pulse: Creates a pulse effect that cycles through the kit. • Light Show: Creates a scanning effect that cycles through the kit and then stops and flashes. Once it is finished flashing, it begins scanning again. • Equalizer: Starting at the center of the front tube, solid light radiates outward, extending to the side tubes, then to the rear tube, illuminating the rear tube from the outside ends to the center, eventually lighting all of the tubes simultaneously. The pattern then moves back to the front of the vehicle in reverse, shutting off the lights as it radiates back to the center of the front tube. The names, order, and descriptions of the modes are:
RkJQdWJsaXNoZXIy MTIxODAy